Drilling through concrete - what to watch for

When Drilling Through Concrete, items To Watch For

When drilling holes in concrete, there is no substitute for quality devices and a sharp masonry drill bit that is also of high quality. If you have an inferior drill with little power, and a dull bit, your holes will certainly not be deep enough, and they will be off-line.

If you utilize quality trademark name drills such as DeWalt, Bosch, Black &

Decker, or Makita, you will certainly be on the ideal track. When you are drilling concrete, there is no replacement for quality and stable power.

You ought to always read the instruction manual of your drill extensively, and being familiar with your device. Understand and research study where all the knobs and controls are found and exactly what they do. You need to know the best ways to set your device up and it needs to become second nature. You need to be comfortable with how the drill deals with you holding on to it.

Be sure and set the depth of your hole-to-be. While some of the machines do have a depth control bar, if it doesn't learn how to set the depth with a pencil mark, or with masking tape.

by: ATLG concrete scanning 

Find out the best ways to hold the drill appropriately while it is running. You will certainly have to hold it like a gun, with your forefinger in place on the trigger. If the drill has a manage for your other hand, be sure to utilize it as planned. Place your hand on the back of the housing on the drill while in operation if the drill does not have an additional deal with.

Before you start to drill, make your mark on the wall with a soft pencil at the point where you are to make the hole. Mark the spot with a dot or a little cross, but do not make the mark too big.

Put the idea of the bit on the mark and apply sufficient pressure to hold it in place, however don't weigh down too hard. You will certainly get make use of

to the amount required by practice. Begin slow, and make a superficial hole that will guide the drill.

Now begin to drill in earnest, utilizing a high speed. If your drill has a hammer function use it periodically. If you don't have a hammer function, stop every ten seconds and pull back, and begin again, letting the bit cool. Continue the exact same tack till you reach the wanted depth.

If the drill has a deal with for your other hand, be sure to utilize it as meant. If the drill does not have an extra handle, put your hand on the back of the housing on the drill while in operation.

Now begin to drill in earnest, utilizing a high speed. If your drill has a hammer function utilize it periodically.

C.S.I.Concrete Scanning &Investigation

54 Hooker Blvd

Broadbeach,

QLD

4218

Contact us: 0426 508 755